Fill Light Component
The fill light component (plFillLightComponent) is a non-physical light for art direction. It brightens or darkens an area in subtle ways, fakes bounce light, or scales the indirect light in a region, for example to darken the ambient light under a table. It has no specular highlights and no shadows, a configurable falloff, and light that can wrap around objects.
Fill lights cost slightly less than a point light. They are not based on the other light components, so they have none of the shared light properties except UseColorTemperature, LightColor, Temperature, SkipGI and GIMultiplier, and no light header or fixture presets.
Component Properties
| Property | Default | Description |
|---|---|---|
LightMode | Additive | How the light combines with the scene lighting, see below. |
UseColorTemperature | Off | Takes the colour from Temperature instead of LightColor. |
LightColor | white | Colour of the light, used while UseColorTemperature is off. |
Temperature | 6550 K | Colour temperature, used while UseColorTemperature is on. |
Intensity | 10 | Strength of the light. A plain multiplier, not a photometric unit; see the modes below. |
Range | 5 m | Radius of the light. It always ends exactly at the range. |
FalloffExponent | 1 | Shape of the fade from the centre to the range. 1 fades linearly. Below 1 the light stays strong and drops off near the edge; above 1 it drops quickly near the centre and fades out gently. |
Directionality | 1 | How much the light wraps around objects. 1 lights only surfaces facing the light, like a normal light. 0 lights all sides equally, as if the light came from everywhere. |
SkipGI | Off | Leaves the light out of indirect lighting. |
GIMultiplier | 1 | Scales the light's contribution to indirect lighting. |
Unlike the other lights, the fill light's colour is not normalised: a darker colour gives a dimmer light.
Light modes
LightMode | Effect |
|---|---|
| Additive | Adds diffuse light, like a soft point light without specular. |
| Subtractive | Removes the same amount of light instead, to darken an area. |
| ModulateIndirect | Multiplies the indirect (ambient and sky) light in its range by LightColor × Intensity, without touching direct light. Values below 1 darken the indirect light, for example to fake occlusion in a corner that a light source still lights properly. Intensity is limited to 0 to 1 in this mode, so it can darken but not brighten. |
In Additive and Subtractive mode the result is Intensity × colour × the surface's albedo, in the same scale as the scene's luminance in nits. In a scene with a physical exposure (see Physical Light Units) the default of 10 is very faint in daylight; tune it by eye.